FEC AFC1150 - Manual (Page 5)

)(& ,QF
w REASSEMBLE TOOL
P Connect the transmission to the motor by installing four screws.
P The output shaft may need to be rotated to align the transmission planetary gears
with the motor output splined shaft.
P Connect the spacer to the transmission by installing four screws.
P Install the snap ring on the output shaft to hold the outer bearing in place.
P If the transmission does not rotate freely after reassembling the tool, then
disassemble it again to isolate and correct the cause.
w INSPECT SPINDLE ASSEMBLY
P Prior to installing the tool, inspect the spring loaded spindle assembly that will
connect to the tool.
P The assembly should compress evenly, without binding.
P Rotate the assembly in the housing and make note of any binding.
P Visually inspect the entire assembly for signs of wear or fatigue.
P Replace parts as required and reassemble.
P Lubricate the inner bearings of the housing as required and reinspect the final
assembly.
P Install the tool onto the spindle, and again inspect for binding.
CHAPTER 8: MAINTENANCE AND INSPECTION
Page 8 - 5