Elite Screens Starling Tension Series - Manual (Page 2)

V022814-JA www.elitescreens.com 2
Pre-Installation
1. Carefully unpack the screen.
2. Always handle the screen in a leveled position on a clean surface.
3. In order to protect the screen from exposure to stains, keep the screen out of contact with foreign
particles such as dust, sawdust, and/or liquids.
Installation Warning
Due to various installation environments, the instructions provided in this user’s guide are for reference
only. Please consult a professional installation company for further installation and safety advice. The
installer must insure that proper mounting hardware is used to provide adequate strength suitable for
the installation. Elite Screens is not liable for any faulty installations.
Individual modifications to this product are prohibited and will void the manufacturer warranty. Please
contact Elite Screens Customer Service for any questions.
These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that the interference will not occur on a particular installation. If this
equipment causes harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more
of the following measures.
 Reorient or relocate the receiving antenna of the device that may be causing the interference.
 Increase the separation between the screen and the device’s receiver.
 Connect the equipment into a different power outlet other than the device.
Note
Regardless of the mounting method, the screen should be securely supported so that the vibration or
pulling on the viewing surface will not cause the casing to become loose or fall. The installer must insure
that the fasteners used are of adequate strength and suitable for the installation location.
Hardware Parts List for the Starling Series
Please make sure all parts listed below are included before proceeding with the installation.
A. Pair of Bracket s x1 B. Screwdriver x 1 C. Steel Expansion
Concrete Anchor x 8 D. Plastic expansion dry-
wall anchor x 8
E. ST5x40 Self-drilling screws x 8 F. Steel Expansion Concrete
Anchor Hook x 2
G. M6x16 screw x 4 M6
nut x 4
H. Spring Snap Link x 2