Electronics International UBG-16 - Manual (Page 24)

7
6
1
3
15
11
16
10
14
2
2
Yel
2
Red
3
Red
5
Red
Extension Cable Harness
Back View (wire side)
Note: 1 Red = Channel #1 Red wire.
1 Yel = Channel #1 Yel wire.
2 0
Appendix A
Adding a Temperature Probe to the UBG-16 or UBG-16T
1
Yel
6
Red
1
Red
7
Red
7
Yel
6
Yel
4
Yel
4
Red
3
Yel
8
Red
8
Yel
5
Yel
If you have an unused channel and would like to add an extension cable and probe to your instrument, perform
the following steps:
1. Order an XCS Extension Cable (at the proper length) and appropriate probe from Electronics
International Inc.
2. Disconnect the cable harness at the Circular Connector on the back of the UBG.
3. Insert the the XCS Extension Cable into the Circular Connector at the proper location (see below).
Once these connectors are installed do not try to remove them without an extraction tool. Unless an
extraction tool is used you can damage the Circular Connector. An extraction tool may be pur-
chased from Electronics International Inc.
4. Follow the appropriate steps in the Installation Instructions for mounting the probes and routing the
Extension Cables.
5. Reconnect the cable harness to the Circular Connector at the back of the UBG.