Teledyne GC-Pro - Gas Chromatograph - HMI Remote Access - Manual (Page 10)

Configuration Model GC PRO
Teledyne Analytical Instruments 4
Configuration
3.1 Settings to Enable HMI VNC Server
To use the VNC connection in the GC PRO HMI, VNC server
must be enabled in HMI5070TH display.
1. Apply power to the HMI and make sure that Ethernet cable is
connected to LAN port.
2. Click the icon in the lower right-hand corner of the screen.
3. Select the Setting icon on the right side of the task bar.
4. Enter the password (default password is 111111).
Figure 3-1: Password Authentication for Changing
System Settings
5. Click the Network tab and note the HMI IP address. Ensure the
correct IP address, subnet mask & Gateway details are entered