Bosch BX12222 Aspiradores sin bolsa BX1 parquet 2200 W EAN 4242002688992 - Manual (Page 14)

13
What kind of dirt can be vacuumed using the vacuum
cleaner?
All kinds of household dirt can be vacuumed using the BX1.
When vacuuming fine particles, note that the motor
protection filter, foam filter and fluff filter must be cleaned at
regular intervals to guarantee the optimum function of the
vacuum cleaner.
Should the dust container be emptied after each use of
the vacuum cleaner?
The dust container should be emptied after each use for
hygiene reasons, or at the latest when the maximum level
(see the mark) is reached.
How often should filter cartridges and motor protection
filters be cleaned/rinsed out?
Ideally, the filters should be cleaned after each use,
especially after vacuuming fine particles, either by tapping
or rinsing, depending on the level of dirt.
The motor protection filter, foam filter and fluff filter must be
cleaned at the latest when the maximum level (see max.
marking on dust container) has been reached.
How often should the washable exhaust filter be
cleaned/rinsed?
The washable exhaust filter should be cleaned regularly for
hygiene reasons by tapping the dust out and must be
rinsed through at least once every 6 months (or washed in
the washing machine at 40°C).
What is the best way to transport my vacuum cleaner?
The BX1 can be transported easily using the ergonomic
carrying handle, e.g. for vacuuming the stairs. It is best to
hold/carry the tube with the floor tool in the other hand.
Frequently asked questions
en
Troubleshooting small problems
Problem
Suction power becomes
noticeably weaker
Bottom flap of the dust
container does not close
Cause
The filter cartridge / motor
protection filter is heavily
soiled.
The nozzle is blocked
The hose / telescopic tube
is blocked.
The hose / handle
is blocked
The dust separator
is blocked
The dust separator joint is
blocked
The bottom flap is soiled
Solution
Clean the motor protection filter, fluff filter and foam filter by tapping
out the dust or rinsing (Fig. 17, 21-23).
Caution: After rinsing, replace the motor protection filter, foam filter
and fluff filter only once they are completely dry (after approximately
24 hours).
Vacuum the nozzle, e.g. using the crevice nozzle
Slide the telescopic tube together and separate the suction pipe
sections.
Loosen and remove the blockage.
Separate the hose from the vacuum cleaner and handle
Loosen and remove the blockage.
Remove the twist-lock cover from the dust separator,
loosen and remove the blockage. Clean the dust separator with a
damp or dry cloth if necessary. Replace the twist-lock cover
(Fig. 26, 27)
Detach the dust separator from the vacuum cleaner, remove the
blockage and click the joint back into the vacuum cleaner (Fig. 28).
Clean the bottom flap, e.g. with a damp or dry cloth. When closing
the flap, ensure that it is fitted correctly.
Innenteil 731 341 A 02.12.2011 12:28 Uhr Seite 13