Bosch Aspiradores de trineo BGL452132 Maxxx 2100W hepa parquet EAN 4242002690698 - Manual (Page 40)

39
en
Figure
Pet hair tool
Ⅲ Floor tool for easy and thorough vacuuming of pet hair.
Ⅲ Push the telescopic tube into the connecting piece of the
pet hair tool until it engages.
Press on the locking collar and pull out the telescopic
tube to disconnect.
Ⅲ To clean, simply vacuum the tool using the suction
pipe/telescopic tube.
Figure
Hard-floor brush
Ⅲ For cleaning hard floor coverings
(tiles, parquet flooring, etc.)
Ⅲ Connect the floor tool and the telescopic tube together.
Figure
Once you have switched off the vacuum cleaner, you can
use the parking aid on the back of the vacuum cleaner if
you wish to stop vacuuming for a short time.
To do this, slide the catch on the floor tool into the
groove on the back of the vacuum cleaner.
When the work is done
Figure
Ⅲ Unplug the vacuum cleaner.
Ⅲ Briefly pull the power cord and release. The cord rewinds
automatically.
Figure
To store or transport the vacuum cleaner, use the storage
aid on the underside of the vacuum cleaner.
Stand the vacuum cleaner up on its end. Slide the catch
on the floor tool into the groove on the underside of the
vacuum cleaner.
Changing the dust bag and filters
Replacing the dust bag
Figure
If the dust bag change indicator lights up brightly and
evenly when the floor tool is lifted from the carpet and
the highest suction power is selected, the dust bag must
be changed, even though it may not yet be full. In this
case it is essential to change the dust bag due to the
type of material it contains.
First check that the nozzle, suction pipe and flexible hose
are not blocked, as this would also lead to the dust bag
change indicator being triggered.
Figure
Open the lid by moving the locking lever in the direction
of the arrow.
18
17
16
15
14
13*
12*
Figure
a) Seal the dust bag by pulling the sealing strip and then
remove it.
b) Insert a new dust bag into the holder and close the dust
bag compartment lid.
! Caution: the lid will only close when the dust bag is
inserted.
Cleaning the motor protection filter
The motor protection filter should be cleaned regularly by
knocking out the dirt and rinsing.
Figure
Ⅲ Open the dust bag compartment lid (see Figure 18).
Ⅲ Pull out the motor protection filter in the direction of the
arrow.
Ⅲ Clean the motor protection filter by tapping it.
Ⅲ If it is very dirty, the motor protection filter should be
rinsed.
The filter must then be left to dry for at least 24 hours.
Ⅲ After cleaning, slide the motor protection filter into the
vacuum cleaner and close the dust bag compartment lid.
Cleaning the foam filter
If your appliance is fitted with a filter frame and foam
filter, the foam filter should be cleaned at regular
intervals by tapping out the dust or rinsing the filter.
Figure
Open the dust bag compartment lid (see Fig. 18).
Pull out the filter frame and foam filter in the
direction of the arrow.
Remove the foam filter from the filter frame and
clean it by tapping out the dust.
If the foam filter is very dirty, it should be rinsed.
After rinsing it, allow the foam filter to dry for at
least 24 hours.
After cleaning, place the foam filter back in the filter
frame, insert the filter frame with foam filter in the
appliance and close the dust bag compartment lid.
! Caution: The vacuum cleaner must not be operated
without the motor protection filter.
21*
20*
19