American Megatrends X6DVA-EG - Manual (Page 11)

Chapter 1: Introduction
1-5
Introduction
Jumper Description Default Setting
J13/J15 PCI #1/PCI-X #5,#6 to System SMB On (Connected)
JA1(*Note) SCSI Channel Term. Enable Off (Enable)
JBT1 CMOS Clear See Chapter 2
JPA1(*Note) SCSI Controller Enable Pins 1-2 (Enabled)
JPF Power Force on Open (Disabled)
JPG1 VGA Enable Pins 1-2 (Enabled)
JPL1/JPL2 LAN1/LAN 2 Enable/Disable Pins 1-2 (Enabled)
JPR1 Power Fail Alarm Reset Open (Disabled)
JWD Watch Dog Enable Pins 1-2 (Reset)
Connector Description
ATX PWR (PW1) Primary 24-pin ATX PWR Connector (Required)
12V PWR (PW2) 12V 8-pin PWR Connector(Required)
COM1 (J4)/COM2 (J5) COM1/COM2 Serial Port Connector/Header
DIMM 1A-3B(J18-J23) Memory (RAM) Slots(1A,1B, 2A,2B, 3A,3B)
DS1-DS5, DS7-DS8 Onboard LED Indicators (*See Chapter 2)
DS7/DS8:POST Code LED (*See Chpt.2 & App.A)
DS9 System LED (*See Chapter 2)
FAN 1-6 CPU/Chassis Fan Headers
GLAN 1/2 G-bit Ethernet Ports
IDE1(J44), IDE2(J38) IDE1/2 Hard Disk Drive Connectors
J1 VGA Connector
J2 Keyboard/Mouse
J10 Parallel (Printer) Header
J24 Floppy Disk Drive Connector
J28 SCSI Connector (*X6DVA-4G only)
J41 IPMI Connector
JF1 Front Control Panel Connector
JF2 PWR LED (Pins1-3), Speaker (Pins 6-7)
JL1 Chassis Intrusion Header
JSLED Serial ATA LED
PCI#1/PCI-E#4 PCI-#1 32-bit slot/PCI-E#4 x4 PCI-E(@2GB/sec)
PCI#5/PCI#6(J9B1/J8B1)64-bit PCI-X 100/PCI-X 133 slot
PW3 Power SMB
PW4 PWR FAIL
SATA0/1(JS0/JS1) Serial ATA0 Header(JS0), Serial ATA1Header(JS1)
WOL (JWOL) Wake-on-LAN Header
WOR (JWOR) Wake-on-Ring Header
USB 0/1(J3) (Back Panel) Universal Serial Bus Ports
USB 2/3 (Front Panel) Universal Serial Bus Headerss
Quick Reference ( X6DVA-4G/X6DVA-EG)
(*Please refer to Chapter 2 for pin definitions.)
(*Note: for the X6DVA-4G only)