Avanti ER2401G - Manual (Page 22)

IMPORTANT:
Always use suitable protective gloves when inserting/removing the broiler pan, shelves, pans and
other cooking utensils from the oven.
OVEN RACK
The rack is designed with stop-locks so that when placed
correctly on the rack supporters, they will stop before coming
hen placing cookware on the rack, pull the rack out to the
, then
oven.
tilt the
ND MAINTENANCE
Stop-lock
completely out from the oven, and will not tilt when removing
food from or placing food on them.
W
bump on the rack support. Place the cookware on the rack
slide the rack back into the
To remove the rack from the oven, pull it towards you,
front end upward and pull it out.
CARE A
¾ GENERAL INFORMATION
•
CAUTION: Before clean ing and maintenance disc
supply.
•
It is advisable to clean when the a
onnect the appliance from the electrical
cold, especially when cleaning the enameled parts.
ice, vinegar, etc.) on the surfaces.
c base.
products and keeping in mind
re eliminates most grime reducing it to
ppliance is
• Avoid leaving alkaline or acidic substances (lemon ju
• Avoid using cleaning products with a chlorine or acidi
•
The oven must always be cleaned after every use, using suitable
that its operation for 30 minutes on the highest temperatu
ashes.
¾ CLEANING YOUR RANGE
• Disconnect the A/C from the main power box or desig
make sure all
nated circuit breaker, turn off the range,
surface units are off and cool before removing anything, then remove all items
including shelves and rack.
ution. The solution should be
quart of water.
Wash the shelves and rack with a mild detergent solution.
The outside of the range should be cleaned with mild detergent and warm water.
ge or cloth when cleaning area of the controls, or any
net with warm water and mild liquid detergent. Rinse well and wipe dry with
Do not use steel wool or a steel brush on the cook-top.
D REFLECTOR BOWLS
• Wash the inside surfaces with a warm water and baking soda sol
about 2 tablespoons of baking soda to a
•
•
• Wring excess water out of the spon
electrical parts.
• Wash the outside cabi
a clean soft cloth.
•
¾ CLEANING SURFACE UNITS AN
eaker and turn off the range to
ore
bowls.
reflector bowls as
o clear the reflector
bowl.
• Pull the su
receptacle.
• Disconnect the A/C from the main power box or
designated circuit br
Surface Unit
make sure that burners are off and cool bef
removing burners and reflector
• Removing the burners and
follows:
• Lift the edge of the unit opposite from the
Receptacle
receptacle, just enough t
Reflector Bowl
rface unit gently out of the mounting
22