Avanti ER2401G - Manual (Page 15)

15
¾ ELECTRICAL CONNECTION
• The appliance must be properly installed and grounded b
with the
y a qualified technician in accordance
National Electrical Code ANSI/NFPA No. 70 (Latest Edition) and local electrical code
electrician.
ard Wiring” or “Power Supply Cord Kit”.
s not supplied, but is available through your local electric supply house.
d at 40 amps with 125/250V
ith strain relief or conduit connector.
nected to the proper electrical voltage and frequency as specified on the
The range can be connected directly to the fused disconnect (or circuit breaker box) through
flexible, armoured or non-metallic sheathed, copper cable (with grounding wire). Allow two to
three feet of slack in the line so that it can be moved if servicing is ever necessary.
For personal safety, the range must be properly grounded.
Remove house fuse or open circuit breaker before beginning installation.
nce unless it is specifically recommended
qualified technician.
nnect this appliance from the A/C power supply
e appliance from the power supply. We
ified technician service your appliance.
requirements. Installation should be made by a licensed
• The range may be connected by means of permanent “H
Power supply cord i
WARNIN
Improper g
G
rounding can result in the risk of electrical shock. If the power cord is damaged, have it
. replaced by an authorized Avanti Products service center
• Use only 3-conductor or 4-conductor UL listed range cord rate
minimum voltage range. These cords may be provided w
• The range must be con
rating label.
•
•
•
• Do not attempt to repair or replace any part of the applia
in this manual. All other servicing should be referred to a
• To minimize the possibility of electric shock, disco
before attempting any maintenance.
NOTE: Turning the appliance off does not disconnect th
recommend having a qual