Avanti ER2401G User Manual
Page 16
3
Screws
Terminal Block
Access Plate
Terminal Block
Ground Strap
Neutral Wire
Power Wires
Power Cord
Bracket
Terminal Block
Neutral Wire
Power Wires
Power Cord
Bracket
Grounding Wire
Grounding Screw
-Wire Power Cord Installation
late on the back
.
al located in the center of the
block. The power leads must be connected to
the outside terminals.
• Plug washers and tighten nuts securely.
• Assemble the Terminal Block Access Plate.
4-Wire Power Cord Installation
• Remove the Terminal Block Access Plate on the back
of the range by removing the 2 fixing screws.
• Assemble the strain relief in the hole on bracket.
• Insert the power cord through the strain relief and
tighten.
• Allow enough slack to easily attach the cord termi
s
to the terminal block.
• Remove the 3 wire terminal nuts and washers from
the terminal block.
• Remove the ground strap from the frame of the range
and terminal by removing its screw and cutting is
shown.
• Plug the terminal holes of the power cord. The neutral wire of the power cord must be connected
to the neutral terminal located in the center of the terminal block. The ground wire of the power
supply cord must be attached to the frame of the range by using the green colored grounding
screw. The power leads must be connected to the outside terminals.
• Plug washers and tighten nuts securely.
• Assemble the Terminal Block Access Plate.
¾ LEVELING THE RANGE
• Remove the Terminal Block Access P
of the range by removing the 2 fixing screws.
• Assemble the strain relief in the hole on bracket.
• Insert the power cord through the strain relief and
tighten
• Allow enough slack to easily attach the cord terminals
to the terminal block.
• Remove the 3 wire terminal nuts and washers from
the terminal block.
Plug the terminal holes of power cord. The neutral or
ground wire of the power cord must be connected to
•
the neutral termin
terminal
nal
as
The range must be level in order to operate properly. The four leveling
legs located on the corners at the bottom of range should be adjusted
by turning them clockwise to make the range higher or counter-
clockwise to lower the range until the range is level. Use a level on
surface units to check the leveling of the range.
16