Alpine 68-21627Z10-A - Manual (Page 10)

10
-EN
3
Press RESET with a ballpoint pen or similar pointed object.
Adjusting Volume
Turn the Rotary encoder until the desired sound is
obtained.
Setting Time
1
Press and hold AUDIO SETUP for at least 2 seconds to
activate the SETUP selection mode.
2
Turn the Rotary encoder to select GENERAL, and then
press
ENTER.
AUDIO  GENERAL  DISPLAY  TUNER  SIRIUSXM
*
 iPod
 BLUETOOTH
* Only for CDE-HD138BT.
3
Turn the Rotary encoder to select the CLOCK ADJ mode,
and then press
ENTER.
The time indication will blink.
4
Turn the Rotary encoder to adjust the hours while the
time indication is blinking.
5
When the hour has been adjusted, press ENTER.
6
Turn the Rotary encoder to adjust the minutes while the
time indication is blinking.
7
Press and hold AUDIO SETUP for at least 2 seconds to
return to normal mode.
Notes
• To synchronize the clock to another clock/watch or radio time
announcement, press and hold ENTER for at least 2 seconds after
setting the “hour”. Minutes will reset to “00”. If the display shows over
“30” minutes when you do this, the time will advance one hour.
• Pressing  will return to the previous mode.
• Pressing and holding  for at least 2 seconds will return to normal
mode.
• If no operation is performed for 60 seconds, the unit will return to
normal mode automatically.
This unit is able to receive signals based on the terrestrial digital radio
broadcasting standard.
When current AM/FM broadcasters are transmitting digital audio and
data services, HD Radio signals are on-the-air in their service area. You
can receive their digital broadcast and enjoy high quality sound.
Depending on the setting of LISTENMODE, this unit will choose to
receive Digital signals or Analog signals. For details, please refer to
“Switching the listening mode” on page 24.
While receiving a live broadcast, you can fix on either Digital signals or
Analog signals to receive. For details, refer to “Setting the Live mode
(LIVE MODE)” on page 24.
Listening to Radio
1
Press SOURCE  to select HD RADIO mode.
Note
• While receiving HD Radio signals,  indicator lights up.
2
Press BAND repeatedly until the desired radio band is
displayed.
F1 (FM1)  F2 (FM2)  AM  F1 (FM1)
3
Press TUNE/A.ME to select the tuning mode.
SEEK DX (Distance mode)  SEEK LO (Local mode) 
MANUAL (Manual mode)  SEEK DX
Note
• The initial mode is Distance mode.
Distance mode:
Both strong and weak stations will be automatically tuned in
(Automatic Seek Tuning).
Local mode:
Only strong stations will be automatically tuned in (Automatic
Seek Tuning).
Manual mode:
The frequency is manually tuned in steps (Manual tuning).
4
Press  or  to tune in the desired station.
Holding down  or  will change the frequency
continuously.
Note
• If SEEK TYPE is set to DIGITAL, the SEEK UP/DOWN functions only
stop on digital station frequencies while receiving HD Radio signal.
Refer to “Setting the Seek Type” on page 24.
Controllable with Remote Control
This unit can be controlled with an optional Alpine remote control.
For details, consult your Alpine dealer. Point the optional remote
control transmitter at the remote-control sensor.
RESET button
Remote control sensor
Radio/HD Radio™
Reception
 
SOURCE/ 
TUNE/A.ME
BAND
Rotary encoder
/ENTER 
VIEW /Tag
Preset buttons
(1 through 6)