Bosch TES80359DE VeroSelection 300 Kaffeevollautomat Front Edelstahl Gehäuse hochglanz anthrazit - Manual (Page 55)

51
TES80.. | 02/2014
en
Insert Bosch cleaning tablet
and close drawer
● Drop a Bosch cleaning tablet in the
drawer 18 and close.
Remove filter  start
Info: If the water filter 29 is activated, the
display will prompt you to remove the filter
29, then press the start button 8 again.
Add 0.5 l water and descaler  start
● Pour lukewarm water into the empty
water tank 11 up to the “0.5l” mark and
then dissolve 1 Bosch descaling tablet
TCZ8002 in it. When using TCZ6002,
2 tablets must be dissolved.
● Press the start button 8. The descaling
programme now runs for about
20 minutes.
Descaling
Not enough descaling fluid.
Refill fluid  start
Info: If there is not enough descaling solu-
tion in the water tank 11, the corresponding
prompt is displayed. Pour in descaling solu-
tion and press the start button 8 again.
Clean and refill water tank
 start
● Rinse the water tank 11 and refill it with
fresh water up to the “ max” mark.
● Press the start button 8. The descaling pro-
gramme now runs for about 1 minute more,
followed by the cleaning programme for
about 7 minutes, and rinses the appliance.
Descaling
Cleaning
Empty drip tray
Replace drip tray
● Empty the drip tray 23 and reinsert it.
Replace the filter if one is being used. The
appliance has completed descaling and
cleaning and is ready for use again.
Important: Wipe down the appliance using a
soft, damp cloth to immediately remove any
descaler residue. Such residue can cause
corrosion. New sponge cloths may contain
salts. Salts can cause rust film on stainless
steel and must therefore be washed out
thoroughly before use.
Thoroughly clean the suction pipe 10d of
the milk frother.
Note: If one of the service programmes is
interrupted, e. g. by a power outage, pro-
ceed as follows:
● Rinse the water tank 11 and refill it with
fresh water up to the “ max” mark.
● Press the start button 8. The cleaning
programme now runs for about 3 minutes,
and rinses the appliance.
Cleaning
Empty drip tray
Replace drip tray
● Empty the drip tray 23 and reinsert it.
The appliance is ready for use again.