Bosch TES80359DE VeroSelection 300 Kaffeevollautomat Front Edelstahl Gehäuse hochglanz anthrazit - Manual (Page 45)

41
TES80.. | 02/2014
en
Contrast
The display 5 contrast can be set from –10
to +10 . The factory setting is +0 .
● Turn the rotary knob 6 to select the
required setting.
Water hardness
● Turn the rotary knob 6 to select the
required water hardness 1, 2, 3 or 4 .
Info: It is important to set the water
hardness correctly, so that the appliance
indicates accurately when the descaling
programme should be run. The factory
setting for the water hardness is 4 .
You can check the water hardness using
the enclosed test strip or by asking your
local water supplier.
● Dip the test strip briefly in water and
check the result after one minute.
Level Water hardness
German (°dH) French (°fH)
1
2
3
4
1-7
8-14
15-21
22-30
1-13
14-25
26-38
39-54
Water filter
A new water filter 29 must be rinsed before
it can be used.
● To do this, press the water filter 29 firmly
into the water tank 11 with the aid of the
measuring spoon 14. Fill the water tank
with water up to the “ max” mark.
● Turn the rotary knob 6 to select start
and press the start button 8.
Place 1 l container
Place suction pipe in container  start
● Place a container with a capacity of 1 litre
under the milk frother 10.
● Place the end of the suction pipe 10d in
the container.
● Press the start button 8. Water will now
flow through the filter 29 to rinse it.
● Next, empty the container.
The appliance is ready for use again.
Info: Rinsing the filter 29 simultaneously
activates the setting for the “change filter”
display.
You can find detailed information about the
water filter in the enclosed filter instructions.
The filter 29 is no longer effective when the
Service - change filter display appears, or
at the latest after two months. It needs to be
replaced for reasons of hygiene and so that
there is no build-up of limescale (this could
damage the appliance).
Water filters are available from retail outlets
or from customer services (see the section
“Accessories”).
If no new filter 29 is used, turn the
Water filter setting to no .
Info: If the appliance has not been used
for a prolonged period (for example, when
you are on vacation), the existing filter 29
should be rinsed before the appliance is
used again. To do this, simply dispense a
cup of hot water.
Transport. lock
● To avoid damage caused by frost during
transport and storage, the appliance must
be completely emptied first.