Pach and Company AWRR - Manual (Page 3)

Step 3 It is not necessary to set the DIP SWITCH B and D.
PROGRAM AND TEST THE SYSTEM
Step 1 With power applied to the receiver, press and release the program button, see fig.1.
Step 2 Test the transmitters from various locations to determine the radio range.
Step 3 Adjust the receiver internal radio range knob to limit radio reception if required (clockwise to increase, counter clockwise to
decrease)
Step 4 Reception pattern will vary depending on antenna used and surrounding structures.
Step 5 Radio indicator will flickers as signal is received.
Step 6 Status indicator lights green when sending Wiegand Data and during receiver lockout operation lights red when hold input is
active.