Nova-Tech CRT V570 - Manual (Page 2)

V570
Industrial strength chemical and
water resistant HVAC surface protector
l Protects your capital assets -
stops corrosion
l Saves thousands on replacement costs -
refurbishes at a fraction of the cost
l Easy to clean surfaces that won’t trap dirt -
fills fine cracks, smooths rough surfaces
l Prevents water damage - eliminates leaks
Characteristics
Boiling Point: N/A
Vapor Pressure (MM HG): NIL
Coating V.O.C: 0.33 lb/gal (40 g/l)
Vapor Density (AIR=1): Heavier than air
Solubility in Water: Insoluble
Appearance: white liquid
Respiratory Protection: None required if good
ventilation is maintained. Otherwise use NIOSH
approved respirator designed to remove particles.
Ventilation: Local exhaust needed at point of
release to maintain exposure below TLV.
Eye Protection: Chemical splash goggles
recommended to avoid eye contact.
Protective Gloves: Rubber gloves.
See Material Safety Data Sheet for more detailed
information.
DATA
APPLICATION PERFORMANCE
V570 is a corrosion proof, high performance surface
protector with high adhesion to vertical, curved or
uneven HVAC surfaces of metal, concrete, plastic,
copper or stainless steel. It is resistant to harsh
industrial coil cleaning materials and is water
resistant. It should be applied under Pancrete on
horizontal surfaces that are under water.
Any system to be coated must be shut down during the
procedure.
PREPARATION: Prep everything first. (V570 begins to set up
in about 20 minutes and will become solid in the container
within 30 minutes.
Remove all dirt, crumbled cement and loose rust from the
surface completely. A drill with a wire brush attachment and/or
pressure sprayer can be used where practical.
If there is any grease, wash the surface with Clean Bond. Allow
to dry. Blow the surface dry with compressed air if available.
Apply on any holes larger than 25 mils in
diameter .
ESTIMATED USAGE: 1 gallon per 100 to 150 square feet.
MIXING: white
Do not make the mistake of mixing the
product and leaving it in the bucket to do other chores or surface
preparation as it will harden and become unusable.)
Take into account any screws, bolts, etc. that may need to be
removed in the future that may be affected by the coating.
CRT Patch ‘N Pour
up to 65 mils
Stir Part B. Pour Part A into Part B. Part B is ,
Part A is clear. Mix by transferring back and forth between
containers 20 times so there are no clear streaks. Follow by 6-12
good mixing strokes with heavy paint stick.
Mix full amount of each can only. Mixing of partial quantities is
not recommended.
APPLYING: V570 is normally applied with a roller, although a
brush may be used for areas difficult to reach. It may be applied
to vertical, slanted, round or uneven surfaces. It also may be
applied to the under side of pipes, ducts or other such surfaces.
CURING TIME: Set up time is dependent upon temperature and
will take 6 to 8 hours at 75 degrees F. Lower temperatures will
result in longer set up times. However, it will set up in the can
within 30 minutes of mixing so must be applied immediately
once Part A and B are mixed.
FOR DRIP PANS AND DRAIN BASINS: Apply 1/4” Pancrete
on top of the V570 according to product instructions.
FOLLOW INSTRUCTIONS CAREFULLY.
Controlled Release Technologies, Inc.
1016 Industry Drive • Shelby, NC 28152
800.766.9057 • fax 704.487.0877 • [email protected]
[email protected]
www.novatech-usa.com
Tel: (866) 433-6682 Fax: (866) 433-6684
Tel: (281) 359-8538 Fax: (281) 359-0084