Nova-Tech Chem-Tech XP Series - Manual (Page 4)

REV. L PN J63031 - 4-
•
WARNING: All pumps are factory tested with water. Remove tubing and
thoroughly dry if the chemical being pumped will react with water (for
example: sulfuric acid).
•
WARNING: Only finger tighten plastic connections (Do not use a wrench).
•
WARNING: Consult licensed plumber and electrician before installation to be
sure to conform to local codes.
• CAUTION: Inspect tubing regularly for cracking or deterioration and replace
as necessary. (Always wear protective clothing and safety eye protection
when inspecting tubing.)
• CAUTION: KEEP FINGERS AWAY FROM ROTATING PARTS.
• CAUTION: If the pump is exposed to direct sunlight, use a U.V. resistant
tubing.
• CAUTION: Follow directions and warnings provided with the chemical from
the chemical manufacturer. The user is responsible for determining the
chemical compatibility with the chemical feed pump.
• CAUTION: Consult with local health officials and qualified water conditioning
specialists when treating potable water
• CAUTION: For accurate volume output, the pump must be calibrated under
all operating conditions.
3. Technical Specifications
Refer to the data plate located on the back of the peristaltic pump. Note that the
data plate will be located behind the back splash cover if installed. Please make
note of the Electrical Rating, Feed Rate and Maximum Pressure of the pump.
Use this information to complete the top three lines in Table 1 (below). For
example, if the Electrical Rating indicated on the data plate of the pump is
230V/60 Hz fill in the first line of the table below. Keep this information handy for
future reference and part replacement.
Figure 1 provides a quick reference for installation dimensional requirements.
Table 1: Technical Specifications
Electrical Rating
Feed Rate (GPD)
Feed Rate (LPH)
Maximum Pressure (PSI)
Maximum Pressure (Bar)
Maximum Ambient Temperature 104
O
F (40
O
C)
Pump Safety Rating ETL,
C
ETL, ETL
SAN
, NSF 50*, NSF 61
Enclosure Rating NEMA 3R (IP31)
Pump Head PVC
Pump Head Tubing Norprene or Fluran
Injection Fitting PVC
Strainer Polypropylene
Suction/Discharge Tubing Polyethylene
Pump Housing ABS or Polycabonate/PBT/15%GF
*Except 50GPD (7.9 LPH) and 80GPD (12.6 LPH) Feed Rate pumps.