beautypg.com

Nm-mm73s, Installation procedures, Cable channel 125 – NetMedia MM73S User Manual

Page 2: Uhf channel 25

background image

NM-MM73S

NetMedia, Inc., 10940 N. Stallard Place, Tucson, Arizona 85737 (520) 544-4567 Fax: (520) 544-0800 Email: [email protected] www.netmedia.com

MAN-MM73S REV0709A

Figure 1 - Setting the modulated channel with the switches. Valid channels are UHF 14-69, CABLE 70-94, 100-125.

NM-MM73S

80 40 20 10 8 4 2 1

ON

OFF

CABLE Channel 125

Add numbers

switched ON

to set channel.

80 40 20 10 8 4 2 1

ON

OFF

UHF Channel 25

Installation Procedures:

1. Remove the End Plate from the modulator assembly and set each channel with the switches as shown in

Figure 1. Choose unused channels that match the tuning mode of the televisions. With antenna tuning,
choose UHF channels from 14-69. With cable tuning, choose CABLE channels from 70-94 or 100-125. There
must be at least one blank channel on either side of each modulated channel to separate it from any other
broadcast, cable, or modulated source. When combining with cable service, be aware that digital data
typically interferes with channels 80-117, even when not subscribed to digital services. If no channels are
available then a filter such as NetMedia’s CNF7080 (ch. 70-80) may be necessary.

2. Connect a video source to an A/V Cable’s yellow RCA video input jack. Adapter’s such as BNC to RCA may be

used as necessary. If audio is available, connect it to the A/V Cable’s white and red RCA audio input jacks.
Insert the A/V Cable’s 3.5mm plug into the modulator’s A/V Input 1. Repeat for A/V Inputs 2 and 3.

3. Connect a coax cable from the modulator’s F connector to the coax from a television or distribution system.

Connect the 12V DC 300mA power supply to an AC outlet. The modulator pictures are now available on the
programmed TV channels.

Figure 3 - Connecting the modulator to a satellite system and distributing to multiple televisions.

Dual LNB

Satellite

Satellite

Multiswitch

w/Ant input

Satellite

Diplexer

Television

Satellite Receiver

Sat In
Ant In

Modulator

Figure 2 - Connecting the modulator to an antenna or cable service and distributing to multiple televisions.

Main cable or

Antenna

Television

Television

Distribution

Panel

or Splitter

Splitter/

Combiner

Optional Ch. 70-80 Filter (NM-CNF7080)

when there are no clear cable channels.

Modulator