Detroit Radiant Products Company DSC Series - Manual (Page 12)

12
Figure 2.3 shows different types of mounting configurations. Depending on the type of mounting you use,
be sure to:
1 Prepare mounting surface. If necessary, weld blocks to mounting structure, drill holes, etc.
2 Fasten beam clamp, screw hook or other type of suspension anchor to hanging point.
3 Attach threaded rod and turnbuckle to anchor. Check that it is securely attached.
4 Attach heater to turnbuckle. Adjust turnbuckle until the heater is level and equal weight distribution is
achieved. Threaded rod must be straight up and down, do not install threaded rod at an angle.
Figure 2.3 • Heater Mounting
DSC Series 2.0 Installation • Heater Mounting
Optional
Mounting bracket
attached to ceiling.
Optional Mounting
bracket attached to
wall.
0° Mounting Angle
30° Mounting Angle
30°
Mounting Angle
0°
Mounting Angle
30°
30°
Bar Joist Clip
Rigid threaded rod
and turnbuckle
(field supplied)