Detroit Radiant Products Company UH Series - Manual (Page 13)

13
UH Series
High humidity or saltwater atmospheres will accelerate heater corrosion and reduce useful life. Do not
install the heater in locations where water (in the form of rain, drips, or spray) could fall onto the gas
ignition components.
The unit is shipped ready for installation. The unit may be installed as shown in Figure 3.3 or inverted
180° depending on the desired location as governed by clearances, vent connection locations, air
direction, gas supply, electrical supply, and service accessibility. The standard installation is installed
how it was factory configured, with the controls on the left side of the heater (when looking at the front).
Configuring the Support Brackets
Standard Installation (Control Panel is on the Left Side)
1 For standard control access, remove the four (4) #10 sheet metal screws and mounting bracket
along the top edge of both the front and back of the unit.
2 Install the front bracket as shown in Figure 3.1 by aligning the screw holes on the bracket with the
screw holes on top of the edge of the unit.
3 Repeat this process for the opposite bracket on the back panel.
Figure 3.1 • Support Brackets
3.0 Installation • Configuring the Support Brackets
3.0 Installation
WARNING
!
Improper suspension of the unit heater may result in collapse and being crushed.
Always suspend from a permanent part of the building structure that can evenly
support the total force and weight of the heater.
Failure to maintain minimum clearance to combustibles may result in fire and/ or
explosion, property damage, serious injury or death. Always maintain minimum
clearances.
NOTICE
Sheet Metal
Screws
Mounting
Bracket
Mounting
Bracket