Detroit Radiant Products Company SW Series - Manual (Page 7)

SW Series Manual
7
Safety Signs and Labels
It is important to provide warnings to alert individuals to potential hazards and safety actions. Signs should
state the hazards for the particular application and be legible to the building occupants. Consult the
factory or a factory representative for additional information on signage compliance.
Safety warning labels must be maintained on the infrared heater. Illustrations of the safety labels, and their
locations, are pictured below. When no longer legible, they must be replaced. Contact either your local
distributor or the product manufacturer for obtaining replacement signs or labels.
1.0 Safety • Safety Signs and Labels
Top View
Rating Plate
F/N: LL01 - Clearance Safety Tag
(Affix adjacent to heater’s controller)
SAMPLE
DETROIT RADIANT PRODUCTS COMPANY
21400 HOOVER ROAD - WARREN, MI
DETROIT RADIANT INFRARED RADIANT ELECTRIC HEATER
FOR INDOOR COMMERCIAL/INDUSTRIAL USE.
FOR PROTECTED AND UNPROTECTED OUTDOOR USE.
NOT FOR INDOOR RESIDENTIAL USE!
(586) 756-0950 - www.drp-co.com
PHASE:
FREQUENCY:
AMPERES
Single
50/60 Hz
6.67
DESIGN COMPLIES WITH:
UL2021 1997 & C22.2 No. 46-M1988 - Electric Air - Heaters
MININMUM
MOUNTING ANGLE:
0 Degrees
Serial No. 10 10 DETR 021400 0001
MODEL NO.
SW-24B1-C16R
VERSION
STANDARD LAMP:
ALTERNATE LAMP:
11/1020
EL-083
EL-073
VOLTAGE
240
WATTAGE
1600
MAXIMUM
MOUNTING ANGLE:
45 Degrees
F/N: LLECL001 - Clearance to Combustibles Label
Electrical Label
(Located inside raceway)
NOTE: USE COPPER CONDUCTORS ONLY
LAMP NO. 1 L1 L2
LAMP NO. 2
LLWEL02-1M-03/11 (CDS)
CAUTION
- VERIFY SUPPLY VOLTAGE -
DISCONNECT FROM ELECTRICAL SUPPLY
BEFORE SERVICING THIS HEATER.
THIS APPLIANCE MUST BE PROPERLY
GROUNDED TO THE ELECTRICAL SOURCE.