DCI Products SmartVent - Manual (Page 6)

Rev20120901
Return Miter SmartVent Directions
When installing SmartVent on a transitional roof you should use the following steps to achieve the best results for
both curb appeal and ventilation.
Cut 45° angle with razor knife starting from the tapered edge working towards the Fabric exterior
Step 1 Step 2
Step 3
Take another SmartVent and miter like this and then.....
Step 4
Step 5
Step 6 Step 7
Install the fabric that is in the box and wrap it over the vent. It is now tapered to blend into the roof!
Step 8 Step 9
If you have questions regarding this process call DCI Products at 1-800-622-4455