Alpine CDA-7865R User Manual
Page 31
29
-EN
1
Antenna Receptacle
Connect to the supplied ISO antenna convertor plug.
2
Audio Interrupt In Lead (Pink/Black)
Connect this lead to the Audio Interface output of a
cellular phone which provides ground shorting when
a call is received.
3
Remote Turn-On Lead (Blue/White)
Connect this lead to the remote turn-on lead of your
amplifier or signal processor.
4
Dimmer Lead (Orange)
This lead may be connected to the vehicle’s
instrument cluster illumination lead. This will enable
the vehicle’s dimmer control to dim the backlighting
of the CDA-7865R.
5
Switched Power Lead (Ignition) (Red)
Connect this lead to an open terminal on the vehicle’s
fuse box or another unused power source which
provides (+) 12V only when the ignition is turned on
or in the accessory position.
6
Power Antenna Lead (Blue)
Connect this lead to the +B terminal of your power
antenna, if applicable.
7
Fuse Holder (20A)
8
Battery Lead (Yellow)
Connect this lead to the positive (+) post of the
vehicle's battery.
For the battery lead and battery connection
Use an extension battery lead (20A)(sold
separately) and connect it directly to the positive
(+) side of the vehicle's battery.
9
ISO Power Supply Connector
!
Ground Lead (Black)
Connect this lead to a good chassis ground on the
vehicle. Make sure the connection is made to bare
metal and is securely fastened using the sheet metal
screw provided.
"
Ai-NET Connector
Connect this to the output or input connector of other
product (CD changer, Equalizer, etc.) equipped with
Ai-NET.
#
System Switch
When connecting an equalizer or divider using Ai-
NET feature, place this switch in the EQ/DIV
position. When no device is connected, leave the
switch in the NORM position.
NOTE
Be sure to turn the power off to the unit before changing
the switch position.
$
Power Supply Connector
%
ISO Connector (Speaker Output)
&
Left Rear (+) Speaker Output Lead (Green)
(
Left Rear (–) Speaker Output Lead (Green/
Black)
)
Left Front (+) Speaker Output Lead (White)
~
Left Front (–) Speaker Output Lead (White/Black)
+
Right Front (–) Speaker Output Lead (Grey/
Black)
,
Right Front (+) Speaker Output Lead (Grey)
-
Right Rear (–) Speaker Output Lead (Violet/
Black)
.
Right Rear (+) Speaker Output Lead (Violet)
/
Remote Control Interface Connector
To remote control interface box.
:
Ai-NET Cable (Included with CD Changer)
;
Front Output RCA Connectors
RED is right and WHITE is left.
<
Rear/Subwoofer Output RCA Connectors
RED is right and WHITE is left.
=
DC/DC Converter
NOTES
•
Do not install the converter at a location subjected to
water such as under the floor mat or air conditioner.
This may cause a malfunction.
•
Do not bundle the DC/DC converter cable with other
audio cables. Doing so may induce noise into your
system.
•
Keep the DC/DC converter away from the Antenna
cables and the rear side of the unit, otherwise noise
may be generated when receiving radio broadcast.
>
RCA Extension Cable (Sold Separately)
To prevent external noise from entering the audio system.
• Locate the unit and route the leads at least 10cm away from the car harness.
• Keep the battery power leads as far away from other leads as possible.
• Connect the ground lead securely to a bare metal spot (remove the coating if necessary) of the car chassis.
• If you add an optional noise suppressor, connect it as far away from the unit as possible. Your Alpine dealer carries
various Alpine noise suppressors, contact them for further information.
• Your Alpine dealer knows best about noise prevention measures so consult your dealer for further information.