Alpine CDA-7865R - Manual (Page 22)

20
-EN
Searching for Titled Discs
(CD Changer only)
If a CD is titled, you can do a search for it. (To title
CDs, refer to "Titling Discs" on page 18.)
1
Press and hold the T.S.M. button for at least 2
seconds. The title blinks in the display.
2
Press the DN g or f UP button to select
the desired disc title.
3
Press the T.S.M. button to play the selected disc.
The unit will automatically search for the disc
and begin play.
4
Press the T.S.M. button for at least 2 seconds to
cancel the disc searching mode.
NOTE
This function cannot be performed when using a multi-
changer switching device.
Multi-Changer Selection
Alpine's Ai-NET system will support up to 6 CD
Changers. When operating two or more changers,
the KCA-400C (Multi-Changer Switching device)
must be used. If you use 1 Switching device, you
can connect up to 4 CD Changers. If you use 2
Switching devices, you can connect up to 6 CD
Changers.
1
Press the SOURCE button on the CDA-7865R to
activate the CD Changer mode.
Alternatively, press the SOURCE button on the
Remote Control (RUE-4185) to activate the CD
Changer mode. Proceed to Step 3 below to
select the desired CD Changer.
2
Press the BAND button on the CDA-7865R or
the RUE-4185 to activate the CD Changer
Selection mode.
3
The CD Changer Selection mode remains active
for 3 seconds after Step 2 is performed. Press
the BAND button until the desired CD Changer
indicator appears on the display.
NOTE
If the selected CD Changer is not connected, the display
will show "NO CHGRX."
Alternatively press the BAND button on the
Remote Control until the desired changer
indicator appears on the display.
4
To operate the selected changer, see "CD
Operation" section.
SOURCE BAND/T.S.M
DN g f UP
CD Player Operation
REMOTE CONTROL UNIT RUE-4185
CD-CHG
SOURCE A.PROC
BAND
PROG
BAND SOURCE