MPM MOD-02 User Manual

Page 33

DIRECTIONS FOR USE

To ensure the highest comfort and safety a vacuum cleaner has been equipped with a water

filter. It is a specially designed device whose role is to absorb the tiniest particles of dust and

dust mites with the use of physical properties of water. Principle of water filter operation is

that the air sucked into the vacuum cleaner goes through a water container, leaving all dust

and dust mites in it.

Dry cleaning

Make sure that the device is disconnected from mains.

Check if the container, tubes and a hose are dry and free from dirt.

Disengage the clamps and lift an engine’s set using a handle.

Take a water filter tank off (drawing 11) and fill it with clean water (max. 2l).

Put a water filter tank back

Put an engine’s set back on the device and lock the clamps.

Connect a sucking hose (E5) (drawing 5), using a fixing element (E1) to sucking inlet of the

vacuum cleaner (B8). Additional accessories can be connected to sucking tube (E9) or direc-

tly to a handle (E8) depending on what you are going to do.

Connect the device to the mains.

Use a switch (A2) to switch a vacuum cleaner on.

To ensure freshness of the air in the room add some drops of freshener (H6) to water in the

container (B1).

Using the equipment described above you can clean:

Floor and carpet head (H5) used to remove dust from carpets, rugs and hard floor surfaces.

It is equipped with rings allowing easier handling and a button. After pressing the button

you can adjust the head for hoovering hard surfaces, for example floors, parquets.

Cracks attachment (H2) is used to clean places that are not easily accessible.

Telescopic sucking tube (C5) is used to suck earth, chips, crumbs and fur.

Narrow brush (D4) and round brush (D3) can be used to remove dust from shelves, books,

lampshades, frames, decorations, curtains etc.

The device has an air blow function. You can use this function in order to dry objects or to

clean stuck washbasin or bath. Connect a sucking hose to cover of HEPA filter case (A6)

(drawing 12) and next switch the device on. You can use a round brush for cleaning if you

remove a part with bristle before.

Attention: Do not use a pump during dry cleaning. Do not use the device without an installed

foam filter.

Wet washing and cleaning

Make sure that the device is disconnected from mains.

Lift an engine’s set above the container.

Make sure that a foam filter is put on (drawing 4).

Take water filter tube off (B4), because its presence during wet cleaning may lead to froth

production.

Put water filter tank back (drawing 11).

Attention: When using a function of surface washing do not put water into the water filter

container.

Pour clean water into the washing liquid container (in order to check its level use the indi-

cator of water level C4) and shampoo (quantity of a shampoo has been given on a bottle).

mod-02_instrukcja.indd 33

27-01-09 21:52:24