MPM MOD-02 User Manual

Page 29

F. Washing tip. It is used for sucking liquids from carpets, rugs and floors. This attachment

also sprays a washing liquid. In case of hard floor surfaces the washing tip must be used

together with an attachment.

F1 – Washing tip.

F2 – Attachment for hard surfaces.

G. Tip for delicate wet washing. This tip is suitable for cleaning furniture upholstery, curta-

ins etc. and for sucking liquid from narrow areas.

G1 - Tip

H. Additional accessories.

H1 – Handle used to fasten accessories

H2 – Attachment for cracks

H3 - Round brush

H4 – Narrow brush

H5 – Carpet and floor hand

H6 – Air refresher

H7 – Shampoo

BEFORE USE

Attention: Make sure that the device is disconnected from mains.

Disconnect a short washing hose (C2), located between washing liquid container (C1) and

engine’s set and carefully take it from the connector (A3) (drawing 1,2).

Disengage the clamps (B6) (drawing 3). Lift an engine’s set with the use of fixed handle

and take water filter tank off (B2).

Next take accessories out and put them in the handle (H1).

During unpacking check if there are all parts and if they are not damaged.

Release locks (D3) from the base and lift water filter container (B1) and washing liquid

tank (C1) (drawing 3).

Put wheels (D2) on the bottom part of a water container (D1).

Make sure that a foam filter (A9) is fixed in a float chamber (A8) (drawing 4).

Fix a water filter tube (B4) (drawing 9), through a rubber gasket (B8) (drawing 10).

Next put washing liquid tank (C1) on a base (D1), fix the water filter container (B1) and

block the locks (D3).

Next put the water filter tank (B2) on the water container (B1) (drawing 11).

Put water filter sponges (B3) in the tank (B2).

Put engine’s set on the container and fix using clamps (B6).

To fix the sucking hose (E5), put a fastening element (E1) to sucking inlet (B8).

mod-02_instrukcja.indd 29

27-01-09 21:52:23