Appendix a - maintenance, Maintenance procedures, Replacing the mcs 352 fuel filters – MotorVac CarbonClean Dual System MCS 352 User Manual
Page 44
Appendix A - Maintenance
Maintenance Procedures
The following maintenance procedures should be performed on a routine basis:
1.
Drain the unit’s fuel reservoirs and replace the fuel filters after every 30 cleaning services for
Gasoline (Petrol), or every 10 cleaning services for the unit’s diesel fuel reservoir for
maximum performance as described in the next section.
2.
Clean the exterior with a non-abrasive cleaning agent or similar product to keep the cabinet
looking new. Check the cabinet for dents or impact markings.
3.
Check all hoses and wires for cuts or frays.
Replacing the MCS 352 Fuel Filters
The unit’s gasoline (petrol) fuel reservoir should be drained and the fuel filter replaced after
every 30 cleanings to ensure maximum system performance and pump life. The unit’s diesel
fuel reservoir should be drained and the fuel filter replaced every 10 cleanings for maximum
performance.
Drain the Fuel Reservoir
1.
Turn
the
SERVICE SELECTOR
switch to either
Gasoline (Petrol) or Diesel FUEL SYSTEM.
2.
On the
Gasoline (Petrol)
side, turn the
PRESSURE REGULATOR
on the control panel
clockwise until it is completely closed.
3.
Attach the unit to the vehicle's battery by connecting the
red
battery clip to the positive (
+
)
battery terminal and the
black
battery clip to a solid ground point as far from the battery as
possible. Turn on the
ON/OFF
switch.
4.
Connect the #060-1400 adaptor to the output (
red
) hose, then drain the fuel from the
unit’s fuel reservoir using the following procedure:
x Set the
TIMER
until it displays five minutes.
x Direct the output (
red
) hose into an appropriate container.
x Press and hold the
START/RUN
switch until the fuel from the unit has been emptied into
the container.
x Release the
START/RUN
switch.
x On the
Gasoline (Petrol)
side, turn the
PRESSURE REGULATOR
counterclockwise until
completely open to relieve any residual pressure.
5.
Enter your initials, the date, and a check mark in the appropriate boxes of the Maintenance
Record at the end of this chapter.