MotorVac CarbonClean Dual System MCS 352 - Manual (Page 16)

Carburetor Setup Procedure
Follow the steps below to connect the unit to the vehicle's fuel system. Make sure the
vehicle has at least 1/8 tank of fuel before beginning this process.
1. Start the vehicle and allow the engine to reach normal operating temperature .
IMPORTANT
Do not perform the setup or cleaning process if the
vehicle’s engine oil or coolant level is low.
If necessary, add oil and/or coolant to the vehicle.
2. Turn the vehicle OFF when normal operating temperature has been
reached.
3. Turn the Gasoline (Petrol) PRESSURE REGULATOR counterclockwise
until the regulator is completely open. Verify that the ON/OFF switch is
turned off .
4. Attach the unit to the vehicle's battery by connecting the red battery clip
to the positive ( + ) battery terminal and the black battery clip to a solid
ground point as far from the battery as possible. Press the SERVICE
SELECTOR switch to the side with Gasoline (Petrol) FUEL
SYSTEM SERVICE.
5. Remove the vehicle's gas cap to relieve fuel tank pressure.
6. Disconnect the vehicle’s fuel line at the carburetor inlet or at the fuel pump outlet. There
should now be two open ends to work with:
x one coming from the fuel pump.
xOne going into the carburetor.
7. Add a pre-mixed gasoline and detergent mixture to the right side (gasoline /petrol) reservoir.
When filling the reservoir, add
1 oz. (30 ml.) of Detergent to 3 oz. (90 ml.) gasoline per
cylinder. See page 3-3 for alternate filling method (Refer to page 3-2 for the proper ratios.)
SEE NEXT PAGE