Shut down, Important – MotorVac DieselTune 4000 User Manual

Page 23

200-8241 REV. 2

DieselTune 4000 Operators Manual

Press the

START

button to restart the unit and continue on with the

RUN MODE

. Verify that the

RUN

timer had gone back to the time last showed before the

Soak Cycle

began. Restart the

engine. The

RUN

mode and the cleaning cycle will continue for the remaining

RUN

time. The

Final Cleaning

time can be adjusted either up or down, if necessary. Press and release the

INCREASE ( +)

DECREASE (

) TIME

buttons to adjust the

Run t

ime either up of down.

Shut Down

When the

Run

time expires, a

unique 6 second alarm

will sound, and the

CYCLE

COMPLETE LED

will be illuminated. When this alarm sounds, turn off the engine. During this

time the pump will continue to run, and supply fuel to the engine.

Press and release the

STOP

button on the control panel. The

Cycle Complete Alarm

will

repeat itself once every minute until the unit is stopped. If the

FUEL LEVEL

display indicates

Empty

during the service or after the

Run

time has expired then a continuous alarm will sound,

and after five minutes the alarm and pump will be shut off.

Using a shop cloth to catch spills, disconnect the

OUT/FILL (RED)

and

RETURN (BLACK)

hoses and adaptors from the engine. Reconnect the engine’s fuel supply and return lines, making
sure to tighten each connection.

Disconnect the system battery clips from the vehicle battery.

Start the engine and check for fuel leaks. Drive the vehicle or run engine to use up any
remaining fuel mixture in the engine.

NOTE

Additional Soak Cycles can be initiated by repeating
steps 2 through 4 as many times as needed.

IMPORTANT

Try not to allow excessive fuel loss when connecting or
disconnecting the hoses from the engine or the engine
may be difficult to start.