MIDLAND CT710 - 2014 - Manual (Page 58)

28 | CT710 Instruction Guide
Table of solutions
PROBLEM SOLUTION
The radio doesn’t switch
on The battery may be exhausted. Recharge it.
Uncorrected installation. Re-install it.
Battery recharge doesn’t
last long The battery pack is over. Change it with a
new one.
Battery pack is not completely charged.
Reception led turns on
but no sound heard Make sure the volume is not too low
Make sure to have the same CTCSS and DCS
codes of your group
The keypad doesn’t work The keypad lock function hasn’t been ena-
bled.
In standby, the radio
transmits without
pressing PTT VOX level has been set too low. Adjust it.
Some functions cannot
be stored Ensure to be on Channel mode. In Channel
mode some functions can be set only
through the programming software.
Reception of other
group signal while
transmitting Select another CTCSS/DCS for your group