MIDLAND CT 210_410 - Manual (Page 7)

E
N
G
L
IS
H
7
Setting Reverse Frequency Function
This.function.is.possible.only.when.you.are.linked.to.a.repeater:.
it.permits.to.invert.the.TX.frequency.with.the.RX.frequency...
In.Channel/Frequency.mode,.hold.down. .for.two.seconds.
until.“R”.appears.on.the.display..Repeat.the.same.procedure.
to.return.to.the.previous.frequency.setting.
Scanning
The.Scan.version.is.very.useful.to.monitor.the.channels.before.
transmitting..
1. Scan all the channels
. In.Channel/Frequency.status,.press. ,. ,. .and.
,. :. the. radio. will. scan. from. the. channel. in. use.
through.all.the.channels..Whenever.any.activity.is.detected,.
the.radio.will.suspend.the.scan.for.5.seconds..It.will.then.
continue.to.scan.unless.you.press. PTT.or. .key.to.end.
scanning.
2. Priority channel scan
. In. Frequency. Mode,. press. ,. ,. . and. .
..The.radio.will.scan.from.the.current.frequency.through.
all.the.frequency.range.within.1MHz..Whenever.any.activity.
is.detected,.the.radio.will.suspend.the.scan.for.5.seconds..It.
will.then.continue.to.scan.unless.you.press.the. PTT.or. .
key.to.end.scanning.
Select scan type
In.Frequency.mode,.press. .and.rotate.the. Encoder.until.the.
display.shows.“SCAN 13”..Press. .and.turn.the. Encoder.
knob.again.to.select.the.scan.type.(TO/CO/SE)..Confirm.your.
selection.with.
.and.exit.by.pressing. .twice.
TO: Time-operated scan
Even.though.the.radio.stops.on.a.busy.channel,.it.will.continue.
scanning.the.other.channels.
CO: Carrier-operated scan
The.radio.stops.on.a.busy.channel.until.there.is.no.activity,.and.
then.radio.begins.scanning.the.other.channels.
SE: Search scan
The.radio.stops.on.a.busy.channel.and.exits.the.Scan.mode..