Amana ARR6102 - Manual (Page 14)

14
Oven Switches Description
Oven Light Switch
Used to light inside of oven. On some models, light turns on when oven door is
opened. On all models, switch located next to clock turns oven light on and off without
opening door.
Other Features
Adjusting Factory
Set Baking
Temperature Oven temperature is set at factory. When first using oven, follow recipe times and
temperatures. If you think oven is too hot or too cool, temperature can be adjusted. Before
adjusting oven baking temperature, test a recipe by using a temperature set higher or
lower than the recommended temperature. The baking results should help you to decide
how much adjustment is needed.
1.
Turn oven temperature knob to OFF.
2. Press and hold HRS + and HRS - pad for approximately 5 seconds.
3. Immediately, press either HRS + or HRS - pad.
• HRS + increases oven temperature by 5°F.
• HRS - decreases oven temperature by 5°F.
• Oven temperature can be changed up to 35°F. When temperature is adjusted cooler
“-” shows in display followed by offset temperature.
• After a few seconds control saves setting and returns to previous display.
12-hour automatic
cancel As a safety feature, oven control automatically shuts off oven after 12 hours of operation.
This feature can be turned on or off.
To allow the oven to operate for more than 12 hours, confirm temperature knob is in OFF
position. Then, press and hold the MINS + and - pads for approximately
4 seconds. Display will change from time-of-day and show “OFF”.
To set oven to shut off after 12 hours, confirm temperature knob is in the OFF position.
Then, press and hold the MINS + and - pads for approximately 4 seconds. Display will
change from time-of-day and show “ON”.
Service codes and
tones Electronic oven control is equipped with a self diagnostic system. Self diagnostic system
alerts you if there is a error or problem in the control. When electronic range control signals
a problem, follow steps listed below.
1. Record “F-code” shown.
• FFF—control malfunction.
• F2—high oven temperature.
• F3—open temperature sensor or circuit malfunction.
• F4—shorted temperature sensor or circuit malfunction.
2. Disconnect electrical supply.
• Disconnecting electrical supply may eliminate “F-code”. If failure continues, contact
an authorized servicer.