Minuteman PORT A SCRUB 14 - Manual (Page 10)

Screw
Disconnect the mains plug before mounting or dismounting the brush. Loosen the screw for fitting the brush before use
of the machine and afterwards for removal of the brush. Change the brush position after each use in order to preclude
one-side wearing.
Loosen the screw before dismounting the brush from the Port A Scrub 14
Dismount the brush from the Port A Scrub 14 after every use. Take the machine into the park position before
—
—
Screw for fitting the Brush
Squeegee Governor
1.Governing handle
Forward
Reverse
2.Front squeegee
3.Rear squeegee
1
2 3
·
The front or the rear squeegee of the Port A Scrub 14 is lowered and has contact with the floor. The operator may
change squeegee position according to the direction of travel of the machine.
Water
During this movement, the rear squeegee takes in the water.
End of operation
Due to the counter-rotation of the brushes, some water remains between the brushes at the end of operation.
Proceed thus as follows at the end of operation
- Take the machine into park position
- Turn suction motor on
- Move the machine a little bit forward
10
˜If the port A Scrub 14 is in its working position and pushed forward, the rear
squeegee has contact with the floor while the front squeegee is lifted.