Minuteman Kleen Sweep KS 32 R (6400.40) - Manual (Page 33)

33
Operation
Check prior to sweeping operation
• Check the charge status indicator
(Fig. 12/1) of the batteries
• Clean the filters using the shaking
device (Fig. 12/2)
• Empty the dirt hoppers (Fig. 12/3)
• Open the bypass flap (Fig. 12/4) in
the case of wet refuse.
• Check the adjustment of the driver's
seat (Fig. 12/5)
Starting sweeping operation
Ensure there is sufficient venti-
lation when sweeping in closed
spaces.
It is not permitted to sweep up
dusts which are considered a
health hazard.
1. Switch the vehicle on with the key
switch (Fig. 12/6).
2. Select the driving direction with the
drive direction switch (Fig. 12/7). Re-
lease parking brake.
3. Switch on the sweeping functions
with the switch (Fig. 12/8).
4. Lower the side broom using the lever
(Fig. 12/9).
5. Actuate the accelerator (Fig. 12/10)
and drive over the area to be
cleaned.
After switching on the sweep-
ing functions, drive off straight
away to avoid the risk of the cy-
lindrical or side broom marking
the floor following rotation.
After sweeping operation
1. Drive to an appropriate service area.
2. Actuate the shaking device.
3. Empty the dirt hoppers.
4. Inspect the broom space for foreign
bodies and remove them as neces-
sary.
5. Clean the machine as necessary.
Do not wet clean electrical
components! Risk of electric
shock!
Pay attention that the dust filter
does not get wet.
Before cleaning, close the by-
pass and install the dirt hop-
pers.
It is not permitted to clean the
vehicle with a pressure washer
or steam blaster.