MAX PJR265(CE) - Manual (Page 18)

18
• When the tool is overheated, stop opera-
tion. After sufficient cool down, continue
operation.
Failure to do so may cause damage to the tool.
8. Drilling in Concrete, Brick or
Stone
For use in Concrete, Brick or Stone material, set
the lever to the
for hammer-drilling.
• When hammer-drilling in Concrete, Brick or
Stone, use proper SDS Plus bit.
1 Hold the tool firmly with both hands.
2 Point the bit straight to the hammer-drill-
ing object.
If the bit is not pointed straight to the ob-
ject, the bit may be caught in the drilled
hole, and it makes difficult to pull the bit
out from the hole.
Do not apply excess pressure to the ham-
mer-drilling object. Applying excess
pressure may reduce working efficiency,
as well as shorten the lifetime of the bit.
3 During the deep hammer-drilling opera-
tion, if the operating speed slows down,
pull the bit slightly out from the hole, so
that the drilled dust is ejected.
If the operation is automatically stopped
completely, release the Trigger switch
immediately, stop operation and pull the
bit out from the hole.
4 When removing the bit from the drilling
object, hold the tool with both hands, pull
the bit out with operating the tool.
5 Do not pour water to the drilling hole. It
may make the bit caught in the drilled
hole.
6 When hammer-drilling in the thin object,
apply a plywood panel to the object, in or-
der to prevent cracking the object.
9. Slow mode
When hammer-drilling a small diameter (smaller
than 5mm) hole in Concrete, operate the tool at
"Slow mode", to prevent the breakage of the bit.
1 (Fig. X) Press the Changeover switch
(Fig. X 8) and check the Status indicator
LED (Fig. X 10) lights up with Green color.
Then operate the tool.
2 When finish operating the tool at Slow
mode, press the Changeover switch (Fig.
X 8) again and check the Status indicator
LED (Fig. X 10) goes off. The tool is at
Normal mode.
• Soon after mounting the Battery pack or a
certain period of time after the last drill-ing/
hammer-drilling, the Status indicator LED
might not lights up or might not goes off,
even though the Changeover switch is
pressed.
When this happens, with no load, pull trigger
once, then press the Changeover switch
again.
• Do not operate the Changeover switch,
when the tool is in operation.
• Use the "Slow mode" only for ham-mer-
drilling in Concrete.
Do not use the "Slow mode" for drilling in
Wood / Metal objects.
"Slow mode" is not suitable for heavy-load op-
eration.
• When the bit is caught in the object, or
when hammer-drilling in an inclined angle,
the tool may be automatically stopped due
to overload preventive clutch.
When this happens, before removing the bit
from the object, remove the bit from the tool, in
order to prevent damaging the tool.
WARNING
CAUTION
CAUTION
WARNING
WARNING
PJR265_CE.book 18 ページ ２０１０年１０月１３日 水曜日 午後４時５１分