Magnum Venus Plastech RT-2000 PRO GUN SATURATOR TRIGGER - Manual (Page 17)

RT-2000 Remote Trigger Manual
Rev. 12/2012 Page | 17
Air Supply In:
3. Locate or create an air supply from the air manifold.
4.
Mark both ends of the poly tube appropriately and put one end through the inner
guard and slide the hose clamp onto the tube and then attach it to the #1 barb
fitting. (see diagram above)
5. Connect the other end of the poly tube to the air supply fitting located on the air
manifold.
Gun Control:
6.
Mark both ends of the poly tube appropriately and put one end through the inner
guard and slide the hose clamp onto the tube and then attach it to the #2 barb
fitting (Gun “ON” signal). (see diagram above)
7.
Attach the other end into the fitting located at the front of the Pro Gun. (see
drawing below)
8. Mark both ends of the poly tube appropriately and put one end through the inner
guard and slide the hose clamp onto the tube and then attach it to the #4 barb
fitting (Gun “OFF” signal). (see diagram above)
9. Attach the other end to the fitting located at the back of the Pro Gun. (see
drawing below)