Magnum Venus Plastech Powerhead MPH_UPPH_VPH–5000 Series - Manual (Page 15)

MPH / UPPH / VPH – 5000 Series Manual
Rev. 5/2012 Page | 15
Introduction:
This manual covers both the 4” and 5-5/8” stroke length Powerheads (VPH-5000 &
MPH-5000). It also covers the VPH-5000-DUO 5” Powerhead Assembly for the DUO
units and the VPH-5000-DHV for the Dual High Volume Unit. This manual also covers
the 5” Powerhead assembly for the Ultra Proportioner UPPH-5000. The process will be
the same for rebuilding the UPPH-5000 Powerhead only few the parts will be different –
please note the correct numbers on the UPPH-5000 parts drawing.
NOTE: It is important to have the correct parts drawing for the Powerhead you are
working on. This will assist in identifying the correct part numbers for the
assembly being rebuilt. The procedures will be the same between the different
configurations but some parts will differ.
The reassembly will require the use of removable Loctite® or equivalent thread lock
compound, Lithium grease (08465) and SUPERLUBE O-ring lubricant.
NOTE: Before starting any service work, release fluid and air pressure from
system. Remove the two air lines from the air motor. In some cases the
Powerhead assembly does not have to be completely removed from the system
for service work.
Please read the manual carefully. Follow the steps in the order given, otherwise you
may damage the equipment or injure yourself.
During Disassembly . . .
As you disassemble the equipment, lay out the components in the correct order and
direction, and have all component drawings available to refer to prior to disassembly.
This will help you to reassemble them.