AT&T 1480 - Manual (Page 13)

10
TELEPHONE OPERATION
AT THE BASE
Speaker
Volume
While on a call,
use to adjust
the volume of
what you hear.
Base Ringer Volume Switch
Use to adjust how loudly the base rings.
Display Dial
Press to dial the
number currently
displayed on
screen.
Make, Answer,
or End a Call
Press
K.
When calling, use
the base keypad
to dial or enter a
memory location.
SPEAKER light is
on when call is
connected.
—OR—
Hold
Press
H to put
a call on hold.
The IN USE light
flashes. To return
to the call, press
K.
NOTE: When
Hold is active,
pressing
P
on handset will
also return
you to the call.
Flash
Access subscriber services while on a call.
Redial
Press to call the last
number dialed at the
base (up to 32 digits).
Page/Intercom
1 Press and release to signal someone at the handset.
A paging tone sounds.
2 When the person at the handset presses
I,
the handset and base can communicate without
tying up the phone line.
3 Press again or press o on handset to disconnect.
On steadily:
handset or base
speakerphone is in use
Flashing slowly:
a call is on hold
1 Dial the
number. Use
< to make
corrections.
2 Press
d
or
K
to place
the call.
1480_book_1ATT 2/25 2/25/02 10:30 AM Page 10