Magnum Venus Plastech System One FRP 4101-00-01 - Manual (Page 9)

FRP SystemOne
Gelcoat
6
5. Thread the 4101-1-1 (Lock Nut) onto the 4101-2-1 (Cylinder) until it
bottoms on the Cylinder shoulder.
6. Install a 7301-9-013 (O-Ring) onto the long threaded end of the
4101-2-1 (Cylinder).
7. Install the 4101-7-1 (Packing Nut), 4101-12-1 (Upper Guide) and
4101-13-01 (Packing Set) onto the 4101-10-1 (Piston Rod).
8. Carefully insert the 4101-10-1 (Piston Rod) through the 4101-14-1
(Outlet body).
9. Carefully press the 4101-13-1 (Piston Rod Packings), and
410112-1 (Upper Guide) into 4101-14-1 (Outlet Body).
10. Screw the 4101-11-1 (Packing Nut) into the 4101-14-1 (Outlet
Body). Screw the Packing Nut until the Packings bottom in the
Outlet Body cavity. Lightly snug the packing nut with a wrench.
11. Insert the 4101-3-1 (Piston Rod Spring) into the 4101-10-1 (Piston
Rod).
12. Insert the 9201-1-5 (5/32” SS Ball) into the 4101-4-1 (Piston Body).
13. Screw the 4101-4-1 (Piston Body) onto the 4101-10-1 (Piston
Rod), compressing the 4101-3-1 (Piston Rod Spring) onto the
9201-1-5 (5/32” SS Ball).
NOTE
See drawing for proper orientation.
NOTE
Care must be taken to not scratch the Piston Rod.
NOTE
Care must be taken to not damage the Piston Rod Packings.