Lightronics FXLD348R3I User Manual

Page 2

Page

FXLD348R3I LED FIXTURE

Version 0.1 OWNERS MANUAL 02/16/2012

www.lightronics.com

Lightronics

Inc.

509

Central

Drive

Virginia

Beach,

234354

757

486

3588

last device. If you have only a few fixtures very close
together and a very short run to the controller then you
may be able to operate without the terminator.

OPERATION

A control panel on one side of the unit is used to set the
operating options. It consists of an LED display and
four buttons

(MENU, UP, DOWN, and ENTER)

Push

to access the operating options. Then use

and

DOWN

to scroll through the available choices.

When you reach the option you want to set or change -
push

ENTER

. Now you can view the current setting

for the option and/or change it. Push

ENTER

to save

your changes and activate the option. See the "MENU
NAVIGATION" diagram for additional details.

There are 7 operation modes: DMX, Blue Level,
Green Level, Red Level, Test Colors, Auto Sequence,
Run Program, and Slave Mode.

DMX OPERATION

Use the

d - - - menu to set the starting address of the

unit. You can set the starting address of the unit with
the UP and DOWN buttons.

The fixture uses three channels with allocations as
follows:

CHANNEL 1: 0 - 255 Red level (255 = Maximum)
CHANNEL 2: 0 - 255 Green level (255 = Maximum)
CHANNEL 3:

0 - 255 Blue level (255 = Maximum)

MANUAL OPERATION

For manual operation the red, green, and blue LED
intensity levels may be independently controlled. Use
the

Cb - -, Cg - -, and Cr - -, menus to set the

levels. The range is from 00 (OFF) to 30 (Full On).

TEST COLORS

The Test Colors option runs all LEDs at the level
selected in its menu. Use the

E - - - menu to set the

level. The range is from 000 to 255. 255 is maximum.

AUTO SEQUENCE

The AUTO SEQUENCE mode switches continuously
through a sequence of all the preset programs . See
the RUN PROGRAM menu for more details. Use the
Au - - menu to set the sequence speed and activate
the option. The range is from 00 to 99. 99 is fastest.

RUN PROGRAM

The unit can operate using 55 preset programs. Preset
0 is "all off". Presets 1 through 7 are solid colors. The
remaining presets are a variety of changing patterns.
Use the Pr - - menu to select and activate a preset
program. The range is from 00 to 55.

MASTER/SLAVE OPERATION

The FXLD348R3I can operate in a Master/Slave mode
where one of the units can synchronize other units of
the same model.

Connect the units together using the DMX IN and
DMX OUT connectors. Set the unit to be the Master
in one of the modes above. Use the

SLAV menu to set

a unit as a slave.

MENU UP

DOWN

ENTER

CONTROL PANEL