Lightronics FXELP10 (prior to May 2009) - Manual

PROFILE SPOT575
USER MANUAL
Page 1 of 3
V20080814
TECHNICAL SPECIFICATIONS
Power Supply: 120VAC, 60 Hz Maximum Ambient Temp.: 45 deg. C
Lamp: 575/750W Maximum Housing Temp.: (steady state): 245 deg. C
Power Consumption: 590W/760W Dimensions (L x W x H): 650 x 180 x 260mm
Weight: 6kg
INSTALLATION
During the installation DO NOT TOUCH THE GLASS BULB BARE HANDED! Please follow the lamp
manufacturer's notes! Do not install lamps with higher wattage. Lamps with a higher wattage generate
temperatures the device was not designed for. Damages caused by non-observance are not subject to warranty.
During the operation, the lamp reaches temperatures of up to 800 degrees C. For the installation, you need a
120V/575W GX-9.5 lamp or 120V/750W GX9.5 lamp.
PROCEDURE:
1. Unscrew the knurled screw of the lamp housing.
2. Remove the lamp housing from the device.
3. If replacing the lamp, remove the old lamp from the socket.
4. Insert a 120V/575W GX-9.5 lamp or 120V/750W GX9.5 lamp into the lamp socket.
5. Do not operate device with opened lamp housing! Reinstall the lamp housing.
LAMP ADJUSTMENT
The lamp holder is aligned at the factory. Due to differences between lamps, fine adjustment may improve light
performance. Strike the lamp, open the shutter and the iris, set the dimmer intensity onto 100% and focus the
light on a flat surface (wall). Center the hot-spot (the brightest part of the beam) using the 3 adjustment screws A,
B, C. Turn one screw at a time to drag the hot-spot diagonally across the projected image. If you cannot detect a
hot-spot, pull the lamp in by turning all screws A, B, C clockwise ¼ turn, one at a time, until the light is evenly
distributed. If the light is brighter around the edge than it is in the center, or if light output is low, the lamp is too
far back in the reflector. Push the lamp out by turning the screws A, B, C counterclockwise ¼ turn
, one at a time,
until the light is bright and evenly distributed.
FOCUSING
1. Loosen the focus button on the underside of the device.
2. Adjust the focus by sliding the lens housing forward or backward.
3. Tighten the focus button.
POWER CONNECTIONS
DANGER RISK OF ELECTRIC SHOCK
The electric connection must only be carried out by a qualified electrician!
I n order to connect the device to the mains, you have to install a power plug connector.
Wiring for the power cable connector is as follows:
Wire Color Function International
Brown Live L
Blue Neutral N
Yellow/Green Earth