Lectrosonics DNTBOB 88 - Manual (Page 12)

ASPEN Digital Processor
LECTROSONICS, INC. 12
Signal Routing
When Dante Controller software is launched, all con-
nected units will appear in the control panel. Click on
the [+] next to the name of each unit to expand the
view to assign subscriptions and establish the signal
routing.
Channel subscriptions are made by clicking on the
crosspoint between the desired transmit channel and
the output on the on the appropriate receiver channel.
A green highlighted check mark will indicate that the
subscription is in effect.
When a receive channel subscription is assigned, the
corresponding transmitter channel will be enabled. If a
crosspoint is left blank, no signal will be transmitted to
minimize the bandwidth usage on the network.
This crosspoint subscription routes audio from
input 1 on DNTBOB88 (the transmitter) to output 1
on BobC (the receiver) using one Dante channel.
Multiple receivers can subscribe to a common transmit
signal on a single Dante channel.
These subscriptions route the audio from input
1 on DNTBOB88 (the transmitter) to outputs 1
through 3 on BobC (the receivers).
Refer to the Help files in Dante Controller for additional
information on channel assignments and the on-
screen indicators that appear in the control panel and
the additional settings and functions available.