Lectrosonics SIXPACK - Manual (Page 9)

Multi-Channel Wireless System
Antennas and Accessories
ALP Series LPDA Antennas
Three high quality directional antennas are available to
extend operating range. The LPDA (log periodic dipole
array) design provides 4.5 dB of gain with a coverage
pattern similar to a cardioid microphone. The ALP500
is a basic unit that provides the benefits of the design
at a low cost, the ALP620 is a “skeletal” design with
protective covers over the connectors, and the ALP650
includes an amplifier with selectable gain for use with
long cable runs and RF splitters.
SNA600 Folding Dipole Antenna
In spite of its low cost, this model is a high quality an­
tenna with a circular coverage pattern in a convenient
folding configuration. Bandwidth within the half power
points is 100 MHz. Set screws on the radials allow
frequency adjustment on centers from 550 to 800
MHz using the guage on the body of the antenna. The
mounting block can be rotated for various mounting
options and includes a standard 50 ohm BNC jack.
Coaxial Cables
A variety of low loss coaxial cables are available to
avoid signal loss through longer runs between antenna
and receiver. Lengths include 2, 15, 25, 50 and 100
foot lengths. The longer cables are constructed of
Belden 9913F with special connectors that terminate
directly to BNC jacks, eliminating the need for adapters
that can introduce additional signal loss.
Customized RF Distribution and Routing
Customized antenna and RF distribution is easy to
configure using the UFM230 amplifier, BIAST power
inserter and several RF splitter/combiners. These
professional grade components preserve signal quality
and suppress noise and intermodulation.
SNA600
Sold in a kit including mounting
strap and hardware
ALP500
ALP620
ALP650
ARG Series Coaxial Cables
Rio Rancho, NM 9