Lectrosonics MM400a - QSG User Manual
Water-resistant transmitter users quick guide
Water-resistant transmitter
Users Quick Guide
If you are using the MM400 in a wet environment (immersion, perspiration, rain scenes etc) - be certain all O-rings are intact
and that a waterproof mic connector (from Lectrosonics, properly installed and sealed) is used on the microphone cable.
WARNING! TO PREVENT WATER DAMAGE or INTERNAL CORROSION!
If the transmitter is wet (either due to immersion or high levels of perspiration), DO NOT OPEN any covers or
connectors. BEFORE OPENING, carefully blot the transmitter dry with a clean paper towel or cloth. Remove all
visible signs of moisture and tap the transmitter on a soft surface such as your hand to shake any retained
mositure loose from under the O-rings. After opening any connector or cover, carefully blot up any remaining
moisture that may have remained around the seal or fallen into the threads. THIS IS IMPORTANT! DO NOT
CLOSE ANY COVER OR CONNECTOR BEFORE MAKING CERTAIN THERE IS NO MOISTURE IN OR NEAR
THE OPENING. After use, it is critical to store the transmitter in a dry place with all covers and connectors
opened to allow any internal humidity to evaporate. Do NOT store wet or sealed up.
A standard 2.5mm tip/sleeve connector can be used with most positive bias lavalier microphones if water protection is not
necessary. DO NOT IMMERSE if the water resistant connector provided by Lectrosonics is not used.
-10
-20
POW ER
LECTRO
UHF
SN: P 216
ANTENNA
AUDIO
LEVEL
MIC
to mic
A
A
B
A
T
T
E
R
Y
MM400
To reverse or
remove belt clip -
pull the belt clip
ends out of the case
holes to remove or
reverse the belt clip
- the clip will work
with antenna up or
antenna down
configurations.
To turn Unit on - insert a dry AA battery
into the battery compartment positive end
first. The cover is the power switch.
Tightening it activates the unit. Turn the
battery compartment cover until the Power
LED lights and the O-ring is slightly
compressed. To turn off temporarily,
loosen the battery cover knob two full
turns. For longer off periods, you can reverse the
battery and tighten the cover to put light pressure on the reversed
battery. For storage periods greater than a day or two, or if unit has
been in a high water environment - see the warning above for
storage instructions.
To set the mic level - turn the level
adjustment knob (between the antenna and the
microphone connector until normal sound
levels cause both LEDs to flash green. The
LED's turning Red indicates limiting
(occasional red is fine).
To set frequency - unscrew the small
knurled knob at the bottom of the transmitter
for 5 full turns. The knob will then move an
additonal 1/8" before it hits the retaining
threads. It does not need to be taken
completely out. Carefully pull up the
frequency cover plate. The switches are
labeled underneath the plate. Set the
switches to match the switch settings shown
on the receiver.
Power output 100mW.
Battery life
Expected battery life is approximately 5 hours with a AA lithium cell, 1.5 to 2 hours with a alkaline cell
at 72 deg F or higher. Rechargeable NiMH can also be used - expect approximately 2-2.5 hours from a
1700mAh NiMH battery.
Battery
AA - Lithium recommended - rechargeable NiMH or Alkaline are also acceptable but battery life will be
shorter. Alkaline batteries will not work well at low temperatures.
®
581 aser Roa - Rio Ranc o,
-
:
8=124
tel (505) 892-4501 or (800) 821-1121 - fax (505) 892-6243
Web: www.lectrosonics.com E-mail: [email protected]