Lectrosonics SRb_SRb5P - Manual (Page 13)

UHF Digital Hybrid Wireless ®
Rio Rancho, NM 13
Whip Antennas
Lectrosonics AMM Series UHF transmitter antennas
follow the labeling specifications in the chart below to
identify operating frequency block. If the antenna cap or
label is missing, refer to the following chart to determine
the frequency of the antenna.
The frequency block is engraved on the outside of the
receiver housing.
33
32
31
21 22 23 24 25 26 27 28 29 30 20 19
470 944
Note: Check the scale of your printout. This line should be 6.00 inches long (152.4 mm).
Whip Length
779 740
470 470.100 - 495.600 Black w/ Label 5.67”
19 486.400 - 511.900 Black w/ Label 5.23”
20 512.000 - 537.500 Black w/ Label 4.98”
21 537.600 - 563.100 Brown w/ Label 4.74”
22 563.200 - 588.700 Red w/ Label 4.48”
23 588.800 - 614.300 Orange w/ Label 4.24”
24 614.400 - 639.900 Yellow w/ Label 4.01”
25 640.000 - 665.500 Green w/ Label 3.81”
26 665.600 - 691.100 Blue w/ Label 3.62”
27 691.200 - 716.700 Violet (Pink) w/ Label 3.46”
28 716.800 - 742.300 Grey w/ Label 3.31”
29 742.400 - 767.900 White w/ Label 3.18”
30 768.000 - 793.500 Black-w/Label 3.08”
31 793.600 - 819.100 Black-w/Label 2.99”
32 819.200 - 844.700 Black-w/Label 2.92”
33 844.800 - 865.000 Black-w/Label 2.87”
740 740.100 - 751.900 White w/ Label 3.18”
779 779.125 - 787.875
797.125 - 805.875
806.125 - 809.750
Black-w/Label 3.00”
944 944.100 - 951.900 Black-w/Label 2.62”
BLOCK FREQUENCY CAP/SLEEVE ANTENNA
RANGE COLOR WHIP LENGTH
NOTE:
Not all Lectrosonics products are
built on all of the blocks covered in
this table.
Factory supplied antennas precut
to length include a label with the
frequency range. Label is not sup-
plied with this kit.