Controlled Products Systems Group 1812-087 - Manual (Page 29)

2.4.3 Automatic Relay Activation Time Zones
This program sequence sets up time zones to automatically activate and deactivate the relays on the
control board. Each relay can be programmed with two independent time zones. Time zones 1 and 2
affect relay 1 operation; time zones 3 and 4 affect relay 2 operation. These time zones can be
independently turned on or off after they have programmed.
1. Press * 3 5 and enter the four-digit MASTER CODE _ _ _ _ (beep).
2. Enter the time zone number _ then press * (beep).
3. Press 0 * (beep) to turn time zone off, or press 1 * (beep) to turn time zone on.
4. Enter the begin time hour and minutes _ _ _ _ then press 0 * (beep) for AM, or press
1 * (beep) for PM.
5. Enter the end time hour and minutes _ _ _ _ then press 0 * (beep) for AM, or press
1 * (beep) for PM.
6. Enter the days of the week that the time zone is to be active _ _ _ _ _ _ _ then press
* (beep). NOTE: Sunday = 1, Saturday = 7. To skip a day (or days) of the week,
enter # in place of the day. For example, if the time zone is to be active Saturday and
Sunday only, enter 1 7 # # # # # in step 6.
7. Repeat steps 3 through 7 to program the other time zones.
8. Press 0# TOGETHER to end this programming step (beeeeeep).
2.4.4 Entry Code Time Zones
This programming sequence sets up a time zone for all four-digit entry codes that have been
programmed into the time zoned entry code location areas. Entry codes that are programmed into
these location areas will not work outside of the programmed time zone. This time zone can be turned
on or off once it is programmed. See 2.6.1 to program entry codes.
1. Press * 3 6 and enter the four-digit MASTER CODE _ _ _ _ (beep).
2. Press 0 * (beep) to turn time zone off, or press 1 * (beep) to turn time zone on.
3. Enter the begin time hour and minutes _ _ _ _ then press 0 * (beep) for AM, or press
1 * (beep) for PM.
4. Enter the end time hour and minutes _ _ _ _ then press 0 * (beep) for AM, or press
1 * (beep) for PM.
5. Enter the days of the week that the time zone is to be active _ _ _ _ _ _ _ then press
* (beep). NOTE: Sunday = 1, Saturday = 7. To skip a day (or days) of the week, enter
# in place of the day. For example, if the entry code time zone is to be active Monday
through Friday only, enter 2 3 4 5 6 # # in step 5.
6. Press 0# TOGETHER to end this programming step (beeeeeep).
1812-065-M-3-07 Page 29