CognitiveTPG A799 User Manual

Page 2

Configure the printer if necessary (page 20).

DECLARATION OF CONFORMITY

Type of Equipment: Information Technology Equipment – Printer

Model: A798-XXXX-XXXX

Model: A799-XXXX-XXXX (X = any alphanumeric character)

Applicable EU Directives:

2004/108/EC (electromagnetic compatibility directive)

2006/95/EC (low voltage directive for product safety)

Harmonized Standards:

EN 55024 (1998/A1:2001/A2:2003) Information Technology Equipment Immunity Characteristics

EN 55022 (2006/A1:2007) EMC, Class B, Limits and Methods of Measurement of Interference

Characteristics of IT Equipment

IEC 60950-1 (2005) Second Edition - Product Safety Standard.

“CognitiveTPG, LLC., 950 Danby Road, Ithaca, New York, 14850, declares that the equipment specified

above conforms to the referenced EU Directives and Harmonized Standards.”

Date: November 28, 2012

Jeffrey C Phoenix, Regulatory Compliance Engineer, CognitiveTPG, LLC

Ref #: 189-1300058 Rev F

Choose a location for the printer.

Connect the following cables based on your configuration, using a-b below.

When using USB (step “b” below),

use caution to ensure the USB

cable is connected to the USB

connector on the back left of

the printer and not into the

cash drawer connector that is
on the right back of the printer.

��

��

��

����

��

Cash drawer (if your installation includes this feature, page 15).

9-pin or 25-pin serial or USB cable (serial: page 16; USB: page 17).

Connect the power cable (page 18).

Route cables as shown for your setup configuration (page 19).

��

��

��

Run a diagnostic test (page 19).

- Set Firmware Features - > 8 clicks

*** A799 - Diagnostics Form ***

Model number : A799-120D-TD00

Serial number

: 0000000000

Boot Firmware

Revision

: V3.02

CRC

: 7E22

P/N

: 189-7940489B

Flash Firmware

Revision

: V3.01

CRC

: 4448

P/N

: 189-7940490A

H/W parameters

Flash Memory Size

: 4 Mbytes

Flash Logos/Fonts

: 1024 kbytes

Flash User Storage

: 960 kbytes

Flash Perm’nt Fonts

: 960 kbytes

Flash Journal Size

: 128 kbytes

SRAM Size

: 512 kbytes

Head settting

: D

Motor ID

: 1

Paper Type Setting

: Type 0, Monochrome

Color Density Adj

: n/a

Print Density, Mono

: 100%

Max Speed

: 250 mm/sec

Paper Width

: 80 mm

Max Power

: 55 W

Knife

: Enabled

Partial Cut

: 125 steps

Paper Low Sensor

: Enabled

No Paper Low Extension

Comm. Interface

RX Buffer Size

: 4096

Interface Type

: RS232/USB

Parameters

Baud Rate

: 115200

Data Bits

: 8

Stop Bit

: 1

Parity

: NONE

Flow Control

: DTR/DSR

Reception Errors

: Ignore

USB Driver Type

: Printer Class

USB Packet w/Error

: Reject

When the printer is configured for USB, this

location will show either: “USB Driver Type:

Native”, “USB Driver Type: Printer Class”, or “USB

Driver: Comm Class”.

Print Test and Configuration Menu Sample.

Samples will vary depending on the printer model.

The A799 is LogoEZ® compatible for ease of

setting-up your logo and two-color design needs.