Codelocks CL475 Narrow Stile, Euro Cylinder - Manual (Page 3)

Before fitting the lock to the door please
ensure the lock is handed to suit the door.
IMPORTANT FITTING NOTES:
i) All locks are supplied handed for right hand
hung doors. See step 1 to change the lock
for a left hand door.
ii) Do not turn the key in the cylinder before the
lock is installed as this may put the gear train out
of alignment.
step 1
Changing the hand of the lock for a left
hand hung door.
The locks are supplied with the gear train on
the reverse of the code plate set up to work
with right hand hung doors.
To fit the lock to a left hand hung door make
the following change:
Remove the 6 retaining screws that secure
the plate covering the gear train (fig. 1)
Remove the large outer gear ring which is
marked with a blue line and the letter R.
Replace it with the large outer gear ring marked
with a red line and the letter L (see below).
Flip over the spindle hub so that it shows a red
line and the letter L. Ensure that the red lines are
aligned and vertical.
Replace the plate with the six screws.
step 2
Fit cam plugs to either side of the mortice lock.
Right hand cam to the code side for a right hand
door and left hand cam to the code side for a
left hand door.
If using existing cam plugs remove the projecting
locating pins using pliers.
step 3
Using the template provided accurately mark
and drill the 4 fixing holes using a 6mm drill bit
ensuring that the template is square to the edge
of the door.
step 4
Fit the blue or red tipped spindle into the cam
on the code side according to the hand of your
door (see below).
Fit the butterfly spindle into the cam on the
Non-code side (see below).
step 5
Fit lever handles according to hand of door.
INSTALLATION INSTRUCTIONS
Door hung on RIGHT
viewed from the code side Door hung on LEFT
viewed from the code side