Clock Audio CAP 002 Phantom power User Manual
Page 2
Microphone cable Connections
Connect your mic input to the PL2 screw terminals:
Connect Phase cold (-) to pin 4.
Connect phase hot (+) to pin 3.
Mixer/ amplifier Connections
Connect your mic mixer to PL1 screw terminals:
Connect ground to pin 1.
Connect phase cold (-) to pin 2.
Connect phase hot (+) to pin 3.
Note: Make sure that your mixer has been set for phantom power output and the correct channel has
been selected. The microphone can then be used.
Clockaudio websi
Sm30092011R1