Clock Audio CAP 002 Line preamp - Manual

Line level Pre Amplifier CAP002
The CAP002 is designed for use with an electret condenser microphone. When connected it will boost
the microphone audio output to a level that can be used to connect to a typical auxiliary line level
input commonly found on amplifiers / mixers or recorders requiring 0.5 Volts RMS (refer to your
external equipment instruction manual).
Power requirements
An external 12V to 24 DC supply with 100mA capacity (not supplied) is required / available from most
high street electrical retail outlets. Some DC adaptors are supplied with a plug already attached these
will need to be removed. Important that you careful check to ensure correct +/- polarity of the 2 cables
when connecting to the CAP002 pin 1 and 2 of PL2 screw terminals.
Connections
Microphone
CAP002 BOARD
M
To Mixer Input
AC/DC power adaptor
(not supplied)