Cleveland Motion Controls ULTRA SERIES UNDER PILLOW BLOCK TRANSDUCER UPB1 REV AA - Manual (Page 8)

U LTRA S ERIES U NDER P ILLOW B LOCK T RANSDUCER MAN-70254 R EV . AA
P AGE 8 OF 18
2 S PECIFICATIONS
Item: Specification:
Transducer Weight
UPB1 UPB2
1.5 lbs.
0.68 kg. 12 lb.
5.4 kg
Mounting Plate with screws
UPB1 UPB2
2.2 lbs.
1 kg. 10 lb.
5 kg
Material
Strain Sensing beam – UPB1: 6061Aluminum
UPB2: 410 Stainless steel
Mounting Plate – 304 Stainless steel
Finish Material UPB1 only: Anodized Aluminum
Mounting Surface Flatness 0.002 inches from one side of transducer to the other.
Bridge Resistance
Steel Transducer: 135-147 Ohms @ 20 o C
Aluminum Transducer: 122-134 Ohms @ 20 o
Gage Type Semi-conductor strain gage, gage factor equals 95 (nominal)
Connector Type M12 Quick-disconnect, 4 conductor, DC keyed
Excitation Voltage 5.6 VDC or VAC (RMS) maximum
(Excess voltage can cause permanent damage)
Nominal Output Signal at Rated
MWF +/- 120 mV per Transducer (with 5.0 VDC or VAC rms excitation
voltage)
Output Impedance Steel Transducer: Approximately 64 Ohms per Bridge leg
Aluminum Transducer: Approximately 60 Ohms per Bridge leg
Ultimate Overload 500% MWF (typ) for units rated 10,000 M.W.F or less
250% MWF (typ) for units rated at 20,000 M.W.F or more
Maximum Voltage, Gage to
Beam or Base (Ground) 50 Volts peak
Operating Temperature Range 0 o F to +200 o F